地磅加减器内的传感器、主线、接线盒都可以安装加减器，简单来说就是利用无线射频技术加减重量，远程改变地磅显示器的结果

性能特点：
1、双向调节，可加可减，可精确调节吨位、公斤。
2、无线遥控，智能解密，性能稳定，效果可靠。
3、体积小巧可随身携带，使用方便、隐蔽、安全，单手即可操作。
4、遥控器对地秤不会产生任何负影响，不按就不会改变原来的数值。
5、操作距离远，在200米以内有用，信号可穿墙或其它障碍物。
6、使用寿命长达5年以上。
7、该产品可防电子拦截、电子干扰。
8、适用于各类模拟数字电子衡器，如电子磅、电子称、皮带称、电子天平等。

地磅加减器安装非常简单，但也要注意以下几点：
Loadometer remote installation is very simple, but also should pay attention to the following points:
1.安装拆卸地磅的遥控器之前，都应该关掉电源，防止整个线路不畅通的情况给领受器芯片通电，电压不稳都可能直接烧坏芯片.就比如我们的手电机池拆卸之前先关机一样。
1. before installation and disassembly of remote control, should turn off the power, to prevent the line does not flow to the receiver chip power, voltage instability can be directly burnt like chips. Before we remove the first electric machine pool off the same.
2.如果在通电的情况下安装，接线则先接信号线，再接电源线；如图先接绿白，后接黑红。外置对插则先连接传感器端，电子遥控器再接仪表端。如图：按顺序接。
2. if in the case of electricity installation, wiring is first connected to the signal line, then the power line; figure first green and white, with black and red. The external plug is connected to the sensor and the electronic remote is then connected to the instrument terminal. As shown: in order.
3.内置对插芯片则要认清板子上的仪表端和传感器端，有中文标记，不要插反了，而且在仪表里面拔插头要小心点，不要把插头指针搞断了。
3. built-in plug-in chip, you should recognize the dashboard on the end of the instrument and sensor side, there are Chinese markers, do not plug in, and in the instrument to unplug the plug to be careful, do not plug the needle to break.
4.安装好后仪表开机，等待仪表归零后，按一下遥控8号键，仪表仍是0便可以进入调试状态了。大家永远要记住的是，按8号键必须归零。
4. after installation of instrument boot, wait for instrument zero, press the remote control button 8, the instrument is still 0 can enter the debug state. We will always remember, press the button 8 to zero.
杰出的安装使用习惯也可有效延长地磅的遥控器的使用寿命，遇到任何不懂的地方。
Good habits are the installation can effectively prolong the service life of the remote control, do not know where any.